Baltimore County has new regulations regarding safety equipment for your rental property. Beginning in February of this year changes have been made to the smoke alarm requirements and in April changes will take effect for the Carbon Monoxide alarms.
Hardwired interconnected smoke alarms are now required on every level of your dwelling excluding unoccupied spaces (attic, crawl, garage). This will still include basements if your home has one. Smoke alarms must all be from the same manufacturer to ensure proper operation and alarms 10 years or older must be replaced.
Beginning in April of this year Carbon Monoxide (CO) alarms are now required on each level of your home if you have fuel burning devices or an attached garage. They must be audible from the sleeping areas and must have a 10 year battery.
While not required of the CO alarms, Interconnected alarms still provide the most safety by allowing more time to exit the home should that be necessary. This is easily demonstrated by CO occurring in the basement and setting off all alarms on each floor before the gasses have left the basement. Smoke and CO gasses that reach the upper floor sleeping areas before the alarm sounds may not provide adequate time to exit the premises before a fatality occurs.
Independent Home Inspection will check your alarms during inspection to make sure they comply with the new rules. As before re-inspections will be performed for no charge after the proper repairs have been made.
The idea behind smoke alarms is fairly simple. If you are alerted by the smoke before he flame reaches your location, you will have more time to escape.
Multiple smoke alarms that can signal each other can alert you even before the smoke reaches your location. These new alarms are ‘interconnected.’ This can be done either with an actual wire or with a dedicated RF (radio frequency) signal.
Many of the homes with fatal home fires were found to have smoke alarms with dead batteries. Either the batteries were simply to weak to operate the alarm or had been removed in anticipation of replacement and simply forgotten.
To resolve this problem newer smoke alarms are supplied with ten year batteries and can be hardwired to the homes electrical system.
Hardwiring and interconnection is a code requirement of new construction in most areas. This presents far more time to get your family safely away from the house in the event that becomes necessary.
A licensing requirement for Baltimore County rental properties requires hardwired and interconnected smoke alarms regardless of the age of the property. Since many of these properties will be retrofitted for smoke alarms the wiring requirement becomes much simpler by the use of ‘radio linked’ alarms.
Combination alarms that detect carbon monoxide (CO) gases as well as smoke are available to accommodate homes that require them. Interconnection provides the same advantage of time as do the smoke alarms.
Don’t become a statistic. Install a smoke alarm if your home does not already have one. Become familiar with how it works and how to test and service it.
October 12, 2016 in Home Inspection, Home Safety
Tagged building codes, Electrical, fire inspection, fire safety, Home Inspection, home safety, house wiring, interconnected, smoke alarms