In this election year we have been besieged with troubling allegations of dishonesty and corruption at the highest levels of government. We have become all too familiar and acceptant of the low standards commonly attributed to politicians.
At Independent Home Inspection honesty is job number one. I report things only as they are without the exaggeration we so often encounter.
Even new homes have some defects. All defects can be fixed. My pledge to you is to simply present them honestly for your evaluation. You will then be in a better position to decide how to proceed.
You may not have given your garage door much thought lately. You press a button and it opens, another and it closes. Have you ever lost power to your door and had to open it by hand? Do you know how to do that?
Your garage door could be quite heavy. Older overhead doors were made entirely of wood. Newer doors are usually aluminum or fiberglass.
There will be a way to disconnect your overhead door from the opening apparatus so you can open it manually. This is usually a short cord and handle hanging from the track about half way to the door. pulling it disengages the door chain or cable and the door is then free to be raised.
Overhead door remote operation should be checked occasionally to ensure safe operation. The ‘electric eye’ operation to prevent door closure is fairly obvious. Recommended height for this beam is 4-6 inches off the floor. Too low and it may shine under your car and allow operation when you are only partially in the garage.
Less obvious is the automatic reversing feature required of overhead doors. This will reverse the door when it strikes an object while descending. This will not prevent damage or injury but will prevent entrapment of the object or person.
The Garage Door Manufacturers Association recommends testing the reverse function with a 2×4 laid across the door opening. Adjustment is usually a simple operation, consult the manufacturers manual for detailed specific information.
Children should be cautioned or forbidden as necessary to prevent dangerous overhead door operation.
The idea behind smoke alarms is fairly simple. If you are alerted by the smoke before he flame reaches your location, you will have more time to escape.
Multiple smoke alarms that can signal each other can alert you even before the smoke reaches your location. These new alarms are ‘interconnected.’ This can be done either with an actual wire or with a dedicated RF (radio frequency) signal.
Many of the homes with fatal home fires were found to have smoke alarms with dead batteries. Either the batteries were simply to weak to operate the alarm or had been removed in anticipation of replacement and simply forgotten.
To resolve this problem newer smoke alarms are supplied with ten year batteries and can be hardwired to the homes electrical system.
Hardwiring and interconnection is a code requirement of new construction in most areas. This presents far more time to get your family safely away from the house in the event that becomes necessary.
A licensing requirement for Baltimore County rental properties requires hardwired and interconnected smoke alarms regardless of the age of the property. Since many of these properties will be retrofitted for smoke alarms the wiring requirement becomes much simpler by the use of ‘radio linked’ alarms.
Combination alarms that detect carbon monoxide (CO) gases as well as smoke are available to accommodate homes that require them. Interconnection provides the same advantage of time as do the smoke alarms.
Don’t become a statistic. Install a smoke alarm if your home does not already have one. Become familiar with how it works and how to test and service it.
October 12, 2016 in Home Inspection, Home Safety
Tagged building codes, Electrical, fire inspection, fire safety, Home Inspection, home safety, house wiring, interconnected, smoke alarms